Full-body Sunbed HB595, HB594 1 EnglisH 6 Dansk 11 DEutscH 16 1 Español 7 Français italiano 7 nEDErlanDs norsk 7 português 5 svEnska 57 türkçE 6 HB595, HB594 6 EnglisH introduction Full-body sunbed This full-body tanner is comparable to those used in professional tanning salons. The 24 Cleo Performance S Reflector tubes, the PowerTan face tanner (HB595 only) and additional features give you the same experience as in a tanning salon. Just as with natural sunlight, you must avoid overexposure (see chapter `Tanning and your health'). general description (Fig. 1) A Tube lamps and starters of the couch B C D E F G H I J K L M N - 11 tube lamps (type Philips Cleo Performance 100W-S-R) - 11 starters (type S12/ Cleo Sunstarter) Acrylic sheets Tube lamps and starters of the canopy - HB594: 13 tube lamps (type Philips Cleo Performance 100W-S-R) and 13 starters (type S12/ Cleo Sunstarter) - HB595: 8 tube lamps (type Philips Cleo Performance 100W-S-R), 5 tube lamps (type Philips Cleo Performance 80W-S-R) and 13 starters (type S12/ Cleo Sunstarter) External body cooler Connecting cable between couch and canopy Mains cord Vents and fans to cool the tube lamps End cover Fan to cool the face tanner (HB595 only) Face tanner (HB595 only) - 1 HP400-SH lamp Stereo Active speakers with line-in connection for CD/MP3 player Legs of the frame and side panel Protective goggles (2 pairs) (type no. HB072/service no. 4822 690 80147) Control panel 1 Function selection buttons ( ¡ / TM) 2 Timer/intensity buttons (- / +) 3 Tanning symbol 4 Face tanner symbol 5 Body cooler symbol 6 On button ( I) 7 Off button ( \) important Read these instructions for use carefully before you use the appliance and save them for future reference. , Check if the voltage that is indicated on the canopy corresponds to the local mains voltage before you connect the appliance. , If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. , If the wall socket used to power the appliance has poor connections, the plug of the appliance becomes hot. Make sure you plug the appliance into a properly connected wall socket. , Water and electricity are a dangerous combination. Do not use this appliance in wet surroundings (e.g. in the bathroom or near a shower or swimming pool). , If you have just been swimming or have just taken a shower, dry yourself thoroughly before you use the appliance. , The appliance must be connected to a circuit that is protected with a 16A standard fuse (in the UK 1A fuse for HB59) or a slow-blow automatic fuse. , Always unplug the appliance after use. , Make sure the mains cord does not get trapped under one of the legs when you move the appliance. , Make sure the vents to cool the tanning lamps in the canopy and in the couch remain open during use. , Never use this appliance when the timer or the control panel is defective or when an acrylic sheet or the UV filter of the face tanner (HB595 only) is damaged, broken or missing. , Make sure children do not play with the appliance. , Do not exceed the recommended tanning time and the maximum number of tanning hours (see section `Tanning sessions: how often and how long?'). , Do not tan a particular part of your body more than once a day. Avoid excessive exposure to natural sunlight on the same day. , Do not use the tanning appliance if you have a disease and/or use medication or cosmetics that increase the sensitivity of your skin. Be extra careful if you are hypersensitive to UV light. Consult your doctor in case of doubt. , Do not use the tanning appliance and consult your doctor if unexpected effects such as itching occur within 48 hours after the first session. , Consult your doctor if persistent lumps or sores appear on the skin, or if there are changes in pigmented moles. , The appliance is not to be used by people who get sunburnt without tanning when exposed to the sun, by persons who suffer from sunburn, by children, or by persons who suffer (or have previously suffered) from skin cancer or who are predisposed to skin cancer. , Always wear the protective goggles provided with the appliance while you are tanning to protect your eyes against overexposure (also see chapter `Tanning and your health'). , Remove creams, lipstick and other cosmetics well in advance of a tanning session. , Do not use any sunscreens or suntan accelerators. , If your skin feels taut after the tanning session, you may apply a moisturising cream. , Colours may fade under the influence of the sun. The same effect may occur when you use this appliance. , Do not expect the appliance to yield better results than the natural sun. Electromagnetic fields (EMF) This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled properly and in accordance with the instructions in this instruction manual, the appliance is safe to use according to scientific evidence available today. EnglisH tanning and your health the sun, uv and tanning the sun The sun supplies various types of energy. Visible light enables us to see, ultraviolet (UV) light gives us a tan and the infrared (IR) light in sunrays provides the heat in which we like to bask. 7 uv and your health Just as with natural sunlight, the tanning process takes some time. The first effect only becomes visible after a few sessions (see section `Tanning sessions: how often and how long?'). Overexposure to ultraviolet light (natural sunlight or artificial light from your tanning appliance) can cause sunburn. Besides many other factors, such as overexposure to natural sunlight, incorrect and excessive use of a tanning appliance may increase the risk of skin and eye problems. The degree to which these effects occur is determined by the nature, intensity and duration of the exposure on the one hand and the sensitivity of the person involved on the other hand. The more the skin and the eyes are exposed to UV light, the higher the risk of keratitis, conjunctivitis, damage to the retina, cataracts, premature skin ageing and the development of skin tumours will be. Some medications and cosmetics increase the sensitivity of the skin. , Therefore it is highly important: - that you follow the instructions in chapter `Important' and section `Tanning sessions: how often and how long?'; - that you do not exceed the maximum number of tanning hours per year (see section `Tanning sessions: how often and how long?'); - that you always wear the goggles provided while you are tanning. tanning sessions: how often and how long? , Do not take more than one tanning session a day, over a period of 5 to 10 days. Wait at least 48 hours after the first session before you take the second session. After this 5 to 10-day course, we advise you to stop tanning for a while. Note:Approximately one month after a course, your skin will have lost much of its tan.You can then start a new course. Note:If you want to keep your tan, do not stop tanning after the course, but continue with one or two tanning sessions a week. Whether you choose to stop tanning for a while or whether you continue tanning on a lower frequency, always keep in mind that you must not exceed the maximum number of tanning hours. For this appliance, the maximum is 17 hours (= 1020 minutes) a year. Example Suppose you take a 10-day course, with an 6-minute tanning session on the first day and a 20-minute tanning session on the following nine days. , The entire course then lasts (1 x 6 minutes) + (9 x 0 minutes) = 186 minutes. Note:In one year you can take 5 of these courses, as 5 x 186 minutes = 930 minutes. table As the table shows, the first session of a tanning course should always last 6 minutes, irrespective of the sensitivity of the skin. If you think that the sessions are too long for you (e.g. because your skin feels taut and tender after the session), we advise you to reduce the length of the sessions by e.g. 5 minutes. Duration of the tanning session in minutes 1st session break of at least 48 hours 2nd session 3rd session 4th session 5th session 6th session 7th session 8th session 9th session 10th session preparing for use Always assemble and move the appliance together with another person. , During assembly, the appliance becomes heavier and more difficult to move. We therefore advise you to assemble the appliance at the place where you are going to use it. , Make sure there is enough free space beside (at least 50cm) and behind (at least 0cm) the appliance. , If you have to place the couch and/or canopy on the floor, make sure the tube lamps face downwards to avoid internal damage. Make sure you place them on a soft surface (e.g. a carpet or rug) to prevent damage to the housing. (Fig. ) 1 First assemble the legs of the frame by fastening the angle sections with the bolts and then fit the side panels. (Fig. 3) Note:the holes in the side panels must be on the front side. Place the couch onto the legs carefully. Make sure the legs slide steadily into the appropriate openings in the couch. (Fig. ) Note:Before you put the couch on the legs, decide how you want the canopy to open.The side of the couch with the connecting holes is the side on which the canopy hinges. for persons with very sensitive skin 6 break of at least 48 hours 10 10 10 10 10 10 10 10 10 for persons with normal sensitive skin 6 break of at least 48 hours 15-20 15-20 15-20 15-20 15-20 15-20 15-20 15-20 15-20 for persons with less sensitive skin 6 break of at least 48 hours 20-25 20-25 20-25 20-25 20-25 20-25 20-25 20-25 20-25 8 EnglisH If you need to move the couch, slide its legs across the floor or carefully lift it slightly off the floor together with another person. , Never try to move the appliance in the way the picture shows. This could cause the frame to become detached from the couch. (Fig. 5) Lift the canopy and position its connecting tubes over the connecting holes. Slide the tubes steadily into the connecting holes of the couch. (Fig. 6) Make sure the cord does not get stuck between the couch and the canopy. Be careful not to get your fingers stuck between the couch and the canopy. 5 Put the plug of the connecting cable in the socket on the lower part of the couch. (Fig. 7) , You can disconnect the plug with a screwdriver as shown in the picture. (Fig. 8) 6 Place the front panel and fasten it with the screws. (Fig. 9) The only purpose of the panel is to enhance the appearance of the appliance. 7 Insert the mains plug into a wall socket. using the appliance For optimum comfort, use the appliance at an ambient temperature of approximately 18°C. If the couch becomes too warm, reduce the room temperature to below 20°C. 1 Select the desired settings for the different functions. selecting a function: , Use the ¡ and TM buttons to select a function. , The blinking symbol indicates which function you have selected. (Fig. 10) - Select · to set the tanning time. - Select ª to set the face tanner (HB595 only). - Select > to set the body cooler. setting the tanning time , Select · to set the tanning time. , Press the + button to put the time forward and press - to put the time backward. (Fig. 11) Keep the button pressed to adjust the time more quickly. setting the face tanner , Select ª to set the face tanner. , Press the + and - buttons to set the intensity of the face tanner. (Fig. 1) - 0 = off - 1 = half intensity - 2 = full intensity , If you do not set the face tanner, the face tanner operates at full intensity. , If you set the face tanner to half intensity (setting 1) when you have just switched on the appliance, the light of the face tanner does not dim right away, but after 1 minute. After the first minute, the light of the face tanner dims or grows stronger right away when you adjust the intensity. setting the body cooler , Select > to set the body cooler. , Press the + and - buttons to set the body cooler. (Fig. 1) - 0 = no body cooling - 1 = one body cooler fan on - 2 = both body cooler fans on , If you do not set the body cooler, the body cooler operates at setting (both fans on). Put on the protective goggles provided. , Only use these protective goggles when you tan with a Philips tanning appliance. Do not use them for other purposes. , The protective goggles comply with protection class II according to directive 89/686/EEC. Switch on the tanning lamps by pressing the green I button. , The display shows the remaining tanning time. , During the tanning session, the dot next to the time indication blinks. , If you want to switch off the appliance during the tanning session, press the red \ button. , You can adjust the intensity of the face tanner during the tanning session (HB595 only). Use the ¡ and TM buttons to select ª and then set the desired intensity. The new setting becomes active immediately. If you do not adjust the intensity within approx. 5 seconds, the remaining tanning time is shown on the display aga ...